Eastwood Gray Epoxy Primer and Catalyst Automotive Car Paint - Quart gtpracing

Specifications

MIXING RATIO

After shaking/stirring primer, thoroughly mix one part primer with one part catalyst. No induction time is required with this epoxy system.

 

SPRAY GUN SETUP

HVLP Gun: Fluid Tip 1.4-1.8 mm Inlet Spray Pressure 25-30 psi
Conventional Gravity: Fluid Tip 1.4-1.6 mm Inlet Spray Pressure 45-55 psi
Conventional Siphon: Fluid Tip: 1.6-1.8 mm Inlet Spray Pressure 45-55 psi
 

APPLICATION INSTRUCTIONS

Eastwood Epoxy Primer should be applied in medium wet coats, with a 30-minute flash period between each (at 70 °F). Typically, one to two coats is enough to achieve the desired 1 mil. dry film thickness, though more material may be applied as needed. Additional build requires longer flash periods between coats. Epoxy primer may be topcoated after approximately 30 minutes (wait 45-60 minutes after applying more than two coats), or up to about five days. After five days, primer MUST be scuff sanded prior to topcoat application. May be sanded (wet) the day after application. Wait two to three days before sanding dry.

Approximate Coverage per Quart is 35 SQ FT